Elecraft P3SVGA User Manual download pdf (Page 6)

 Use a grounded anti-static mat on your work bench.

 If you choose to use a soldering iron to work on your P3 for any reason, be sure your iron has an ESD-

safe grounded tip tied to the same common ground used by your mat or wrist strap.

Tools Required

1. #1 size Phillips screwdriver. To avoid damaging screws and nuts, a power screwdriver is not

recommended.

2. Pliers or wrenches for installing 1/4” (6.4mm) nuts 3/16” (4.8 mm) jack screw nuts.

The following tools are strongly recommended:

1. ESD wrist strap.

2. Static dissipating work pad.

Parts Included

The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged

or missing, contact Elecraft for replacements (see Customer Service and Support, pg 4).

ILLUSTRATION DESCRIPTION QTY.

ELECRAFT

PART NO.

P3SVGA Circuit Board Assembly

ESD Sensitive.

1 E850482

Jackscrew Nut, 4-40 (may be mounted on

the Circuit Board Assembly Connector)

2 E700078

Lock Washer, Inside Tooth, #4 (may be

mounted on the Circuit Board Assembly

Connector)

2 E700010

Power cord assembly (used to connect the

P3 directly to a 10 to 15 VDC power supply).

NOTE: Do not attempt to power your P3 from

the K3’s 12V outlet when equipped with the

P3SVGA. See Connections on pg 5.

1 E980221

1 2 3 4 5 6 7 8 9 10 11

No comments

Elecraft P3SVGA User Manual Page 6