ELECRAFT P3 HIGH-PERFORMANCE PANADAPTER P3SVGA OPTION INSTALLATION AND OPERATING INSTRUCTIONS Rev C, May 23, 2012 Copyright © 2012, El
10Connect the ribbon cable to the P102 on the P3SVGA board as shown in Figure 7. Place the boards on a firm surface to avoid over-stressing them. B
11Replace the rear panel assembly on the P3 as shown in Figure 9. Tilt the assembly so the P3SVGA board does not strike the screw head for the rear
2 Contents Introduction ...
3 Introduction The P3SVGA Super Video Graphics Array option adds wide screen display capability to the P3. It features a dedicated, high-speed Fast F
4 Customer Service and Support Technical Assistance You can send e-mail to [email protected] and we will respond quickly – typically the same da
5 Operation The P3 must have firmware version 01.10 or later installed. See Firmware Upgrades in your P3 Owner’s Manual for information on how to che
6 Use a grounded anti-static mat on your work bench. If you choose to use a soldering iron to work on your P3 for any reason, be sure your iro
7Installation Procedure Disconnect power and all cables from your P3. Remove the six screws to free the top cover ( Figure 2 ) and lift the cove
8Lift the I/O board out of the P3 and unplug the ribbon cable (Figure 2 ). Take care not to damage the board. Hold the board while working the con
9Remove the plastic covering from the AUX. DATA, EXT. DISPLAY and KEYBOARD openings on the rear cover, but leave the covering over the SENSOR openi
Comments to this Manuals