Elecraft • www.elecraft.com • 831-662-8345ELECRAFT KXB30 30-METER ADAPTERAssembly and Operating InstructionsRevision A, Oct. 14, 20
2Parts Inventoryi Caution: Diodes D1 and D2 can be damaged by static discharge. Before handlingthese parts, put on an anti-static wrist strap or touc
3PC Board Assemblyi A fine-point, temperature-controlled soldering iron (700-800 degrees F) is required to assemblethis kit. A high-wattage iron or o
4 Install R4 and R5 (1 k, brown-black-red). Solder and flush-trim as before.i L1, L2, and L3 may be labeled R1, R2, and R3 on your PC board. Install
5Figure 1Installation Strip off all of the insulation from 5.5 inches (14 cm) of the supplied hookup wire. Cut the bare wire into four 1" (2.5 cm
6 The free ends of the wires will be routed to matching labeled holes on KX1 PC board. Due to spaceconstraints on the top, the holes are labeled on th
7 Remove the adhesive backing from the rubber bumpers and install them as shown in Figure 2a. If thebumpers don't sit flat on the board, make sur
8 Switch to 30 meters and align the two trimmers on the KXB30. You can peak them while listening toWWV at 10 MHz, or using signals or noise in the ham
Comments to this Manuals