A Backlighted LCD for your K1(K1BKLTKIT)Tom Hammond - NØSS, July 27, 2006Rev CThanks to Wayne Burdick, N6KR for suggesting this implementation of back
MODIFICATIONRemoval of K1 Front Panel1. Remove the four (4) case screws which secure the K1 front panel to the main body of the radio.2. Pull the fron
a small amount of fresh solder to each connection to assist in initially 'wetting' the solder wickduring the solder removal process. Use a m
cleanly between the PC board pins for the LCD (DS1) and, when placed up against C4 (just tothe right of the LCD), it will just clear the leftmost four
21. The LED current-limiting resistor must now bechosen. A value of 330 ohms will give you a currentdrain of about 6mA with adequate illumination. Ava
If you find the illumination to be too dim (or too bright), select an appropriate value resistor andreplace the resistor originally chosen and install
Comments to this Manuals