Elecraft KRX3 User Manual download pdf (Page 38)

Plug the SUBIN interface board into J64A on the K3 RF board as shown in Figure 46. J64A is directly in

front of the KIO3 board in the rear left corner of the K3. Be certain the connector on the SUBIN board is aligned

with J64A so all pins are engaged.

Figure 46. Mounting the SUBIN Interface Board.

Locate J64B on the K3 RF board. It is between the crystal filters and the front panel shield that holds the

KREF3 and KSYN3 boards. J64B should have a plug in the third hole matching a missing pin on the SUBOUT

connector P1. The plug is shown on the Keying the KRX3 SUBOUT Connector instruction sheet provided with

the kit. If it is not present, install it according to the instructions.

Plug the SUBOUT interface board in J64B on the K3 RF board as shown in Figure 47. J64B is between the

K3 roofing filters and the front panel. Be certain the SUBOUT board is aligned so all pins of P1 are engaged

with J64B.

Figure 47. Mounting the SUBOUT Interface Board.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

No comments

Elecraft KRX3 User Manual Page 38